Used Clean In Place - CIP Systems

Stock# 51188008

New/ Unused Three (3) Tank CIP (Clean In-Place) System (Will build to your specifications) System consists of the following: 2 x 2,000 316 stainless steel acid & caustic chemical tanks, Insulated, Top manway, Level transmitter, RTD Temperature probe, 1 x 2,000 L 304 stainless steel Water re-use tank, Single skin, Top manway, 1 x Spray ball, Level transmitter, RTD Temperature probe, Automated valving, 9 x Automated butterfly valves, 1 x Automated control valve, 7 x Solenoid valves, Manual valving, 17 x Manual valves, 1 x Stainless steel sanitary design centrifugal pump for CIP supply including Stainless steel shroud, VSD (variable speed drive), Local motor isolators, 2 x Stainless steel centrifugal pumps for CIP heating including Stainless steel shrouds, Local motor isolators, 2 x Concentrated diaphragm chemical pumps, 1 x Grundfos sanitizer dosing pump, 1 x 500 micron (mesh size) stainless steel filter, 1 x 2 section stainless steel plate heat exchangers for heating CIP solution, 1 x Stainless steel plate heat exchanger for heating water, 3 x Concentrated chemical suction lances, Stainless steel process control cabinet including Remote I/O, 1 x VSD, 3 x Conductivity probes, 4 x RTD temperature probes, 3 x Level transmitters, 1 x Mag flowmeter, 3 x Level switches, Electrical switchgear, Ethernet switch, etc. Our freight specialists can assist you with door to door transportation and all customs documents needed to make the process go as smoothly as possible.

Stock# 53485003

Used 3-Tank Clean In Place (CIP) System.

Stock# 11252233

Unused A&B Process Systems 2-Tank CIP Skid with (2) 250-Gallon 316L Stainless Steel Tanks with insulated vessels rated for 15 PSI / Full Vacuum at 350 degrees Fahrenheit to minus 20 degrees Fahrenheit Minimum Design Metal Temperature (MDMT). Skid mounted system with 57" wide x 116" long. Includes 20 HP centrifugal pump, driven by 230/460 Volt, 3510 RPM, 3-phase, 60 Hz motor. Offered with Ashcroft pressure gauges and Rosemount temperature transmitters. Vessels are mounted on Mettler Toledo 0959 load cells. Non-product contact parts are 304 stainless steel. Product contact parts are 316L stainless steel. System rated for 480 Volt, 3-phase, 60-cycle. Previously used in pharmaceutical environment. NO CONTROLS WITH THIS SYSTEM.